Grid view List view

Showing all 2 results

TQ Systems KRT2 StandardOut of stock
Sold Out

TQ Systems KRT2 Standard

COM Radio, 8.33 kHz, 57 mm

Available in 2-3 weeks

The KRT2 is designed for 8.33 kHz and 25kHz channel spacing that will become the new international standard for airborne communication. Switching between the 8.33 and the 25 kHz mode is effortlessly simple. Standard or dynamic microphones can be used. A built-in-test facility increases flight safety. The dual watch mode that allows scanning of two different channels is included. The KRT2, with its integrated VOX/Intercom circuit, allows communication between pilot and co-pilot.

Remote control unit available The KRT2 VHF-AM transceiver has a full graphic LC-display that allows for easy reading under all light conditions, including full sun.

The display illumination can be dimmed or turned off.

Quick View
Add to quote
Details
TQ Systems KTX2Out of stock
Sold Out

TQ Systems KTX2

Mode S Transponder

Available in 2-3 weeks

The KTX2 mode S transponder is like all Dittel Avionik a highly efficient device. During the development the following parameters have been taken in account:

  • low weight of only 360 g
  • minimal power consumption
  • low cost

These parameters are the argument especially for gliders, ultralight aircraft and balloons, to be equipped with the KTX2. The current consumption of a Mode-S transponder is generally an indication which depends on numerous of parameters. In Mode S operation in busy airspace it can cause a high rate of queries per minute. In this case, the transponder will respond accordingly and frequently increasing the total energy consumption.?In the technical data we provide to you data you can trust when you designing a battery-operated system.

The installation of the KTX2 is quite simple. The panel cutout corresponds to the standard 57 mm. The body length of only 144 mm allows plenty of room for the handling in full panels and greatly simplifies the installation.

The installation of a level encoder may be omitted, of course. The KTX2 has already an integrated high – precision pressure sensor. Just connect the hose from the ‘static port’, hang up antenna and power supply and that was the whole installation.

 

Quick View
Add to quote
Details